Table of Contents
Advertisement
Installation of 16mm Aileron Servos
Important Note:
A 16mm Servo can be used if it is one of the newest high end servos with
a torque of 10+ kg/cm. This is sufficient if not flown under extreme
conditions with oversized jet turbines.
It is recommended, however, to install a standard size servo, if the very
top performance and speed is desired. A special servo cover and mount
for standard size servos is optionally included in the kit!
For the installation of the aileron servos please use the 2.9 mm
sheet metal screws with washer once more. For symmetrical
travel please align the servo horn perpendicular to the linkage!
You mount the servo hatches with the 1.9 x 10 mm screws. Create
the linkage with a 20 mm long M3 all thread and turn on two
spring steel clevises. Use Loctite or CA glue (just like you did with
the elevator linkage) because there is no room for counter nuts.
Advertisement
Table of Contents
