Table of Contents
Advertisement
When sanding areas on the inside of the composite sandwich parts to prepare the
surface for gluing something onto it, do NOT sand through the layer of
lightweight glasscloth on the inside foam sandwich. It is only necessary to rough
up the surface, with 80/120 grit, and wipe off any dust with acetone or de-
natured alcohol (or similar) before gluing to make a perfect joint. Of course, you
should always prepare both parts to be joined before gluing for the highest
quality joints. Don't use Acetone for cleaning external, painted, surfaces as you
will damage the paint.
Tip: For cleaning small (uncured) glue spots or marks off the painted surfaces you
can use old-fashioned liquid cigarette-lighter fuel, like 'Ronsonol' or equivalent.
This does not damage the paint, as Acetone and many other solvents will, and
this is what we use at the factory.
At CARF-Models we try our best to offer you a high quality kit, with outstanding
value-for-money, and as complete as possible. However, if you feel that some
additional or different hardware should be included, please feel free to let us
know. Email us: feedback@carf-models.com. We know that even good things can
be made better !
Did you read the hints and warnings above and the instructions carefully?
Did you understand everything in this manual completely? Then, and only
then, let's start assembling your CARF-Models DG-800S. If not, please read it
again before you continue.
Equipment:
This is a list of suggestions for equipment to be installed in your DG-800S:
1. 2 16mm aileron servos like Graupner DES 678 or JR 3711 HV
2. Or: 2 20mm aileron servos like Graupner DES 707 or JR DS 8411 HV
3. 8 20mm standard size servos with at least 15 kg/cm or 120 oz/in like the above
4. Powerbox Sensor oder Evolution or any other high quality power bus
5. Receiver batteries of appropriate size, depending on your planned flying time
6. Receiver with at least 10 outlets
Advertisement
Table of Contents
