Important Safety Instructions - Liebert 115V User Manual

IMPORTANT SAFETY INSTRUCTIONS

This manual contains important safety instructions that should be followed during
the installation and maintenance of the UPS and batteries. Please read this
manual thoroughly before attempting to install or operate this UPS.
WARNING:
§
To prevent the risk of fire or electric shock, install the UPS in a temperature
and humidity controlled room, free of conductive contaminants.
§
Operate the UPS only from a properly grounded/earthed AC supply.
§
To reduce the risk of electric shock, do not remove the cover, as it has no
user-serviceable parts inside. Some components are live, even when AC
power is disconnected. For service, contact a qualified technician.
§
To reduce the risk of fire, use the proper rating when replacing the fuse.
CAUTION:
Although your UPS has been designed and manufactured to assure personal
safety, improper use can result in electrical shock or fire. To insure safety,
please observe the following rules:
§
Turn off and unplug your UPS before cleaning. Do not use liquid or aerosol
cleaners. A dry cloth is recommended to remove dust from the surface of
your UPS.
§
Do not install or operate your UPS in or near water.
§
Do not place UPS on an unstable cart, stand, or table.
§
Do not place UPS under direct sunlight or close to heat emitting sources.
§
To allow proper ventilation of UPS, do not block or cover sides of unit.
§
Do not place UPS power cord in any area where it may get damaged by
heavy objects.
§
Follow all warnings and instructions marked on the UPS. Do not attempt to
service the UPS, as it has no user-serviceable parts inside. Refer all repairs
to qualified service personnel.
ATTENTION:
Turn off and unplug your UPS from the outlet and contact qualified service
personnel if:
§
The power cord or plug is damaged.
§
Liquid has been spilled on the UPS.
§
The fuse blows frequently.
§
The UPS does not operate even when user follows the operating
instructions.
CONDITIONS OF USE: The input receptacle must be within 6 feet (1.8 meters)
of the UPS.
Your UPS provides conditioned power to connected equipment. Maximum load
must not exceed that shown on UPS rating label. If uncertain, consult your
distributor or Liebert.
Placing magnetic storage media on top of the UPS may result in data corruption.
This equipment can be operated by individuals without previous training.
SAVE THESE INSTRUCTIONS
2