4.5 NCT-196N DSC/NBDP Modem
4.5.1
Self ID, Navigation and Radiotelephone Setting
The settings described in this section have been made prior to shipment from the factory.
ATTENTION
To enable setting adjustment, remove the cover of the NCT-196N DSC/NBDP MODEM
and insert the switch(S1)-No.3 into the OFF. When adjustment is complete, re-insert
the switch(S1)-No.3 into the ON and replace the cover.
Note
Dip switch setting
Switch No.
S1-1
S1-2
S1-3
S1-4
S1-5
S1-6
S1-7
S1-8
Procedure
(a)
Both press
menu.
54
Modem function
EEPROM initialize
EEPROM writing
TEST signal sending
AF signal wait
HT signal using
-
-
MENU
and "POWER SWITCH" to access the following the "INSTALLATIONSETUP"
INSTALLATION SETUP
Self-ID
: 111111111
Group-ID
: 022222222
Navigation : NMEA0183
Serial cont: ON
Data clear : OFF
SPACE signal send
MARK signal send
DOT signal send
70-TIME MESSAGE send
WKR frequency : 2,187.5
WKR step test
History
S1
Insert the S1-3 to
OFF at the time of
Self-ID setting.
Function
ON: DSC only, OFF: DSC and NBDP
ON: Disenable, OFF: Enable (expect ID)
ON: Disenable, OFF: Enable
ON: Disenable, OFF: Enable
ON: Normal, OFF: Factory setting
ON: Not use, OFF: Use
S1
Re-insert the
S1-3 to ON after
Self-ID setting.
Default setting
OFF
ON
ON
OFF
ON
ON
ON
ON