Canon VB-H43 Operation Manual page 56

• See "Important" on p. 98, p. 104 for precautionary notes
regarding Admin Tools configuration when image stabilizer is
set.
• See "Important" on p. 142 for precautionary notes regarding
the Viewer when image stabilizer is set.
• [Pan/Tilt Speed Control] can also be set using [Pan/Tilt/
Zoom] in the Control for Admin panel of the Admin Viewer
(p. 149).
Day/Night (when Auto is set)
(1) [Switching Brightness]
Set the brightness at which Day Mode and Night
Mode will be switched when [Auto] is selected in
[Day/Night]. Select [Darker], [Slightly Darker],
[Standard], [Slightly Brighter] or [Brighter]. Select
[Darker] if you want to capture video in color as much
as possible.
Select [Brighter] to reduce noise. Note that this mode
switches to black & white sooner.
(2) [Response (sec.)]
Set the time in seconds needed for judgment on
switching between Day Mode and Night Mode when
[Auto] is selected in [Day/Night]. Select [60], [30],
[20], [10] or [5].
The mode will switch between Day Mode and Night
Mode if brightness remains above or below the level
set in (1) for the number of seconds specified.
Select [30] or [60] if brightness changes frequently,
such as when a light source passes in front of the
camera. Select [5] or [10] if change in brightness is
minimal.
Installation Conditions
(1) [Dome]
Select whether or not a dome is used. To use the
camera with a dome housing unit, select [Use].
(2) [LED Setting]
Select [Turn Off] or [Turn On] for the LED operation
status on the camera. Set to [Turn Off] if you do not
want to turn on the LED.
Set to [Turn Off] if an optional indoor dome housing for
the camera is used, if reflected LED light enters the
capture area or otherwise interferes with image
capture, or if you do not want to show that the camera
is operating.
56
(3) [Image Flip]
Select [Disable] or [Enable] for the orientation of the
camera video.
Note
• For the focus ranges when the dome is set to
[Use], see the note on p. 55.
•
seconds when booting even if the [LED Setting] is set to [Turn
Off].
Camera Position Control
(1) [Restricted to Presets]
Set the camera control preset to [No Restriction] or
[Preset Only]. The administrator can limit camera
control by non-administrators to preset angles by
selecting [Preset Only].
(2) [Camera Position without Control]
Select either [Do not return to Home Position] or
[Return to Home Position] as the action when no
control privileges are requested by users and the
home position has already been set.
When [Return to Home Position] is selected and no
users have control privileges, the camera moves
automatically to the home position. This function
requires the home position of the camera be set in
advance. Set the home position using Preset Setting
Tool (p. 100).
External Input Device 1, 2 / External Output Device 1, 2
[Device Name] for external input device/external output
device
Be sure to enter each device name in order to identify
the corresponding external device being connected.
Enter [Device Name (alphanumeric characters)] using
up to 15 characters (ASCII characters (space or
printable characters) excluding the double quotation
mark (")).
Note
The external device name set here will be shown when the Admin
Viewer or included RM-Lite is used.
The LED will light for several