[Reboot Item] Setting Items Requiring Rebooting - Canon VB-H43 Operation Manual

[Reboot Item] Setting Items Requiring Rebooting

The following settings that require rebooting before
changes take effect can be found on a single page.
• LAN, IPv4, IPv6, Installation Conditions (VB-H43/
VB-M42 only), HTTP Server
(1) [LAN]
LAN interface, maximum packet size settings (p. 48)
(2) [IPv4]
IP address, IPv4 settings, etc. (p. 48)
(3) [IPv6]
Settings regarding IPv6 (p. 49)
(4) [Installation Conditions]
Dome setting (p. 56)
(5) [HTTP Server]
Authentication method, HTTP, and HTTPS port
settings (p. 66)
Important
These settings relate to network connectivity*. If any setting is
changed to a value that may disable camera connection from
the active web browser, a dialog box appears and alerts the
user.
Click [OK] to apply the new setting.
Depending on the new setting, it may not be possible to
connect to the camera again after rebooting. If this happens, a
candidate URI for reconnecting the camera will appear if
available.
Try the URI displayed to reconnect the camera.
If you cannot connect to the camera through the displayed URI,
contact your System Administrator.
* [LAN Interface], [Maximum Packet Size], [IPv4 Address Setting
Method], [IPv4 Address], [Subnet Mask], [IPv6], [Auto (RA)],
[Auto (DHCPv6)], [IPv6 Address (Manual)], [Prefix Length],
[HTTP Port] and [HTTPS Port].
5
83