Table of Contents
Advertisement
5.4.3
Failover mode
About failover mode
This function allows the automatic switch to a defined Backup source when the Main input signal is miss-
ing.
The display will automatically restore the Main input as soon as the signal is back.
The Backup source is the input selected as "2nd Picture Source" with "2nd Picture Mode" = "Off".
This Main & Backup combination is stored at the moment the function "Failover mode" is set to "Enabled".
Failover Mode is not selectable when either the Main Source or the 2nd Picture Source is set to "Au-
tosearch".
Failover mode is automatically disabled when either the Main Source or the 2nd Picture
Source is changed. A warning message "Failover off" appears on the screen for a few
seconds.
Returning to the original Main & Backup combination will automatically re-enable the
Failover feature.
For the MNA version only, Failover mode will be activated 7 seconds after the Nexxis
signal becomes unavailable (delay required to allow a Nexxis layout change)..
To enable/disable failover mode
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the Failover mode submenu.
4. Enable/Disable failover mode as desired and confirm.
5.4.4
OSD setting
5.4.4.1
OSD Horizontal Position
To adjust the OSD horizontal position
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the OSD setting submenu.
4. Select OSD Hor. Pos.
The command bar OSD Hor. Pos. is highlighted.
5. Set the OSD horizontal position as desired and confirm.
5.4.4.2
OSD Vertical Position
To adjust the OSD vertical position
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the OSD setting submenu.
(451920611333)K5903030 MDSC-2242 09/10/2014
5. Advanced operation
35
Advertisement
Table of Contents
