Table of Contents
Advertisement
3. Enter the Image Position submenu.
A small OSD menu will be activated indicating the horizontal and vertical image position offset.
4. Use the
and
5. Use the
and
6. When finished, use the
5.2.4
Auto Adjustment
This menu item is only available when VGA input is connected.
About auto adjustment
When auto adjustment is activated, the phase and clock per line parameters are automatically adjusted.
To activate auto adjustment
1. Bring up the OSD main menu.
2. Navigate to the Picture advanced menu.
3. Enter the Auto Adjustment submenu.
The automatic picture adjustment is activated: the phase and clock per line parameters are automati-
cally adjusted.
5.2.5
Phase
This menu item is only available when VGA input is connected.
About phase
If the result of the Auto Adjustment procedure described above isn't satisfactory, the Phase can be man-
ually adjusted by following this procedure.
To manually adjust the phase
1. Bring up the OSD main menu.
2. Navigate to the Picture advanced menu.
3. Enter the Phase submenu.
The command bar Phase is highlighted.
4. Set the phase as desired and confirm.
5.2.6
Clock/Line
This menu item is only available when VGA input is connected.
About clock/line
If the result of the Auto Adjustment procedure described above isn't satisfactory, the Clock/Line can be
manually adjusted by following this procedure.
(451920611333)K5903030 MDSC-2242 09/10/2014
keys to move the picture up and down.
keys to move the picture left and right.
key to exit from the small OSD menu.
5. Advanced operation
29
Advertisement
Table of Contents
