3xLogic VISIX 360 Hardware Installation Manual page 11

2. Fix the three supplied screws half-deep to the ceiling, leaving enough space to hook the camera body.
3. Connect the corresponding power cable, network cable, audio and alarm cables.
4. Align the screw holes to the inserted screws, hook the camera body to the screws, and route the camera
body to secure the camera with the screws.
5. Hammer the half-deep screws into the ceiling totally.
6. Install the camera cover to the camera body, and fix them by tightening the lock screw on the camera
cover.
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
Hardware Install Manual | VISIX 360 Network Camera
Figure 2-2 Fix the Screws
Figure 2-3 Install the Camera
Figure 2-4 Tighten the Lock Screw on the Camera Cover
11