CUMMINS ALLISON JetScan iFX i100 User Manual page 29

9
10
Image sensors
Use a dry microfiber towel to clean the stacking sensor.
11
Next, use a dry microfiber towel to clean the stacking-sensor reflector, which is
located on the upper-transport plate directly above the stacking sensor.
Press down on the release levers to unlock the upper-transport plate from the
12
open position. Press down on the upper-transport plate until it locks in the
closed position.
13
Lower display panel to the operating position.
14
Use a dry microfiber towel or vacuum to remove any remaining dust in the pocket.
Use a dry microfiber towel to clean the pocket-sensor lens located in the pocket
15
between the two gray stacker wheels.
Next, use a dry microfiber towel to clean the pocket mirror located directly
across from the pocket-sensor lens.
16
Clean the touch-panel display with a dry microfiber towel.
Use a dry microfiber towel to wipe buildup off
the image sensors shown at left.
Avoid damaging touch-panel display.
Helv. Bold
Oblique
41.29
Only clean touch-panel display with dry microfiber towel as
directed.
Daily cleaning procedures | JetScan iFX
Vacuum underneath the
upper-transport plate
(shown at far left), as well
as the top of the lower-
transport plate (shown
at left).
® i100 scanner | 29