Communicating By Phone; (Voice-Guided Vdmp3) - Paradox Magellan MG5000 User Manual

Partition
It is possible to arm or disarm specific partitions. The partitions must be prefaced by the letter A, and separated
by commas for individual partitions. It is also possible to affect a series of partitions by writing TO between the
start and end partitions of that series. The list of partitions must be followed by a period.
Examples:C1234.ARM.A1.
C1234.ARM.A1TO2.
Phone Number
This informs the system of which phone number must be notified by SMS to confirm the status change.
Example:C1234.ARM.A1,3,5TO7.5555551234
IP Information
It is possible to receive the IP address of the GSM module via text message. The GSM module will then send a
text message to the specified phone number displaying the IP address of the GSM module. A valid user code
must be entered to receive the IP address. The IP address can be used to configure remote software. Consult
your installer for more information.
Example:C1234.IP.5555551234
GSM Module Phone Number
Enter the phone number of your GSM module here (consult your cell phone provider)
__________________________________________

Communicating by Phone

(Voice-Guided VDMP3)

You can communicate with your security system by phone by using a system accessory called the VDMP3
Voice Dialer (sold separately). The VDMP3 is a module that can be programmed to call one or more telephone
numbers in the event of an alarm. For example, when an alarm occurs at your store during off-hours, every
employee can receive notification via telephone: (sample message) "Area 1 in alarm. Zone 3. Press 1 to disarm
the system..."
You can also call the VDMP3 from an outside line, enabling you to arm or disarm the system as well as activate
PGMs. The VDMP3 essentially turns any outside telephone into a keypad. For example, you unexpectedly have
to extend a business trip, and for security reasons, would like to turn on your office's lighting. Simply use your
phone to toggle the lights on and off. Consult your installer for more information.
VDMP3 Instructions
How do I call the VDMP3?
1 From an outside line, dial the telephone number to which the VDMP3 is associated.
NOTE: If the telephone number that is associated with the VDMP3 has an answering machine, hang up the
telephone when the line rings, and dial the telephone number again within the time limit set by your
installer.
2 When the VDMP3 answers the line, you are prompted to enter your user code.
3 System status is given, as well as options to arm/disarm (1) and control features (PGMs) (2).
NOTE: If you hang up while in communication with the VDMP3, you must wait 2 minutes before connecting
again. To avoid having to wait, press "#" to disconnect from the VDMP3 before hanging up.
Refer to the following page for a diagram that details how to use the VDMP3.
20 User Guide