TOHATSU BFT 250A Owner's Manual page 98

2 PIN COUPLER (BLUE)
FUEL TUBES
WATER SEPARATOR BRACKET
5. Disconnect the 2-pin coupler
(blue).
6. Remove the suspension strap from
the water separator bracket, then
remove the suspension strap from
the water separator.
7. Bind the two fuel tubes with the
tube clips to prevent the fuel
leakage, disconnect the fuel tubes.
DRAIN VALVE TUBE CLIPS
SUSPENSION STRAP
8. Bind the drain tube with the tube
clip, disconnect the tube from the
drain valve.
DRAIN TUBE
TUBE CLIP
WATER
SEPARATOR
MAINTENANCE
WATER SEPARATOR CUP
O-RING (Replace)
9. Remove the three screws holding
the water separator, delete the
water or deposit from the inside of
the cup.
10. Reassemble the water separator in
the reverse order of removal. Use
a new O-ring.
TIGHTENING TORQUE:
3.4 N·m (0.34 kgf·m, 2.5 lbf·ft)
SCREWS
95