Differential Removal - Arrma Fury Manual

Differential Removal and Replacement
1.3mm Hex Driver
1
Remove rear wheels with 7mm nut driver/cross wrench.
Disconnect motor wires.
3
Remove driveshafts on both sides. Use this
opportunity to inspect axles and driveshafts for wear
(Page 15).
5
Remove two rear shock tower screws and two motor
© 2013 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.
2mm Hex Driver 2.5mm Hex Driver
guard screws with 2mm hex driver.
ARRMA-RC.COM/
Tools Required
SUPPORT/
7mm Nut Driver
2
Separate both rear camber-link ball joints with long-nose
pliers.
4
Remove long motor guard bolt with 2.5mm hex driver. Remove two
short motor guard bolts and four gearbox/chassis bolts with 2mm
hex driver.
6
Hinge motor guard up and remove gearbox.
23
or Cross Wrench Long-nose Pliers
WWW.ARRMA-RC.COM