Radio-gear Maintenance
Receiver Access
ARRMA-RC.COM/
Tools Required
SUPPORT/
1
(Raider only) Remove four roof bolts with 2mm hex
driver, remove roof.
Steering Maintenance
Steering Access
ARRMA-RC.COM/
SUPPORT/
I f y o u f i n d y o u r c a r ' s
steering feels loose it may mean you have to
adjust the servo saver. To do this you will have
to get access to the steering mechanism.
1
Disconnect steering link ball-joints on both sides with long
nose pliers.
3
© 2013 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.
2mm Hex Driver
Tools Required
2mm Hex Driver
Separate front sub assembly from rest of
If you want to replace or upgrade the steering servo, ESC
(electronic speed controller) or re-bind the transmitter, you
will need to access the receiver.
2
Remove four bolts securing receiver box lid with 2mm
hex key, remove lid. Reinstallation is the reverse the
removal process.
7mm Nut Driver or Cross Wrench
2
Re m o v e f o u r b u t t o n s c r e w s a b o v e a n d f o u r
countersunk screws below servo box with 2mm hex
driver.
4
Remove two bolts holding steering assembly to chassis
chassis.
25
Long-nose Pliers
with 2mm hex key.
WWW.ARRMA-RC.COM