Wheel Bearing Replacement - Arrma Fury Manual

Rear Axle Maintenance (cont.)
3
Rotate rear hub carrier to allow
better access and push axle up
through bearings.

Wheel Bearing Replacement

E v e r y 5 0 r u n s o r s o i t m a y b e
necessary to inspect the wheel bearings for wear. Running the
model in dusty, sandy or wet conditions will mean that this will need
to be performed more frequently.
1
Remove front and rear wheels with 7mm nut driver/cross wrench. Remove
hex hub and drive pin from axles.
3
Turn steering and push axle
through front bearings.
6
Rotate rear hub carrier and
push axle through bearings.
DESIGNED FAST. DESIGNED TOUGH.
4
Clean and check condition of
rear axle. If worn as shown
above, replace axle.
ARRMA-RC.COM/
SUPPORT/
4
Remove bearings from steering block.
Inspect, clean and replace if necessary.
7
Remove bearings from hub carrier. Inspect,
clean and replace if necessary.
16
5
Refit driveshaft, camber-link, drive pin,
rear hex hub and rear wheel.
Tools Required
7mm Nut Driver or Cross Wrench Long-nose Pliers
2
Separate rear camber-link from ball joint with
long-nose pliers.
5
Refit front axles, hex hubs, drive
pins and front wheels.
8
Re f i t r e a r a x l e , c a m b e r - l i n k
balljoint, rear hex hubs, drive pins
and rear wheels.
© 2013 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.