Driveshaft Maintenance; Rear Axle Maintenance - Arrma Fury Manual

Driveshaft Maintenance

Every 20 runs or so it may be
necessary to clean and re-grease the drive-shafts as
well as check for wear and/or damage. Running in dusty,
sandy or wet conditions will mean that this will need to be
performed more frequently.
1
Remove rear wheel with 7mm nut-driver/cross wrench.
Separate camber-link from balljoint with pliers.
3
Visually check driveshaft is not twisted or bent. If necessary,
replace. Re-grease driveshaft ends and refit.

Rear Axle Maintenance

Ev e r y 2 0 r u n s o r s o i t m ay
be necessary to inspect the rear axle for wear. Running the model
in dusty, sandy or wet conditions will mean that this will need to be
performed more frequently.
1
Remove rear wheel with 7mm nut driver/cross wrench.
© 2013 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.
ARRMA-RC.COM/
SUPPORT/
ARRMA-RC.COM/
SUPPORT/
Remove rear hex hub and drive pin from axle.
Tools Required
7mm Nut Driver or Cross Wrench
2
Remove driveshaft. Clean driveshaft ends and axle inputs
and differential out-drives.
4
Refit camber-link ball-joint with long nose pliers
and refit rear wheel with 7mm nut driver or cross
wrench.
Tools Required
7mm Nut Driver
2
Separate camber-link from ball joint with long-nose pliers.
15
Cloth Grease Long-nose Pliers
or Cross Wrench Long-nose Pliers
WWW.ARRMA-RC.COM