Outdoor Grill (OG) Series
Halogen Lamp Assembly (Light Socket)
The halogen lamp assemblies are attached to the rear
hood assembly with retaining tabs and a screw. The
light socket wire leads are routed down through a hole
in the rear deck of the burner box and tied into a wire
harness attached to the rear flange of the burner box.
NOTES:
•
If the grill is sitting on a cart, the rear panel of the
cart will need to be removed at this time.
•
If the unit is built in and there is no rear access to
the grill below the rear hood shell, then the grill will
need to be pulled forward 3" - 6" (76 - 152 mm). If
pulling the grill forward, take care to not damage the
gas supply line.
To remove a halogen lamp assembly, first remove the
rear hood shell, then:
1. Cut wire leads 2" - 3" from wire harness connection
point (See Figure 4-26).
2. Open hood, then extract light assembly mounting
screw and pull entire assembly away from rear
hood assembly (See Figure 4-27).
NOTE: When re-connecting wiring with wire nuts, use
only high-temperature wire nuts. See part #801189.
Hood Switch
The switch mounting bracket is attached to the side of
the burner box with screws. The body of the hood
switch passes up through a hole in the lower flange of
the switch mounting bracket, with an adjusting ring
threaded onto the switch below the flange and a nut
threaded onto the switch above the flange to hold it in
place. A rod resting on the switch actuator passes up
through holes in the switch mounting bracket and pro-
trudes slightly above the top surface of the burner box.
NOTE: Whether on a cart or in a built-in application,
the grill will need to be pulled forward 3" - 6" (76 - 152
mm). When pulling the grill forward, take care to not
damage the gas supply line.
To remove the hood switch (See Figure 4-28):
1. Disconnect switch electrical leads.
2. Use a Phillips-head screw driver to extract switch
bracket mounting screws.
3. Lower switch assembly down until switch rod clears
hole in burner box.
4. Use a 14 mm open-end wrench or crescent wrench
to remove nut from body of switch
5. Pull switch from mounting bracket.
Component Access / Removal
Cut Here
Figure 4-26. Halogen Lamp Wires
Lamp
Assembly
Figure 4-27. Halogen Lamp Assembly Removal
Figure 4-28. Hood Switch Removal
4-13
Lamp
Assembly
Bracket
Nut
Screws
Switch
#814144 - Revision A - july, 2009