Handle And Endcaps; Grates; Briquette Trays; Zone Dividers - Wolf OG36-LP Technical & Service Manual

Component Access / Removal

Handle and Endcaps

A socket head set-screw inserted through the bottom of
each standoff holds the handle in the standoffs. The
standoffs are then attached to the hood with screws
passing through the hood into the back of the standoffs.
To remove the handle assembly (See Figure 4-4):
1. Open hood, then use a Phillips-head screwdriver to
extract standoff mounting screws and pull assembly
from the hood.
2. To remove handle from standoffs, use a 5/64" Allen-
wrench to loosen the set-screw in each handle
standoff and pull the handle from the standoffs.

Grates

The grates rest on ledges at top, inside front and back
of the burner box.
To remove a grate (See Figure 4-5):
1. Use finger clearance hole at front of grate to lift the
front up and pull the grate forward slightly.
2. While holding the front up, grab back of grate and
lift it straight up off of the burner box.

Briquette Trays

The briquette trays sit on ledges at the inside front and
back of the burner box, just below the grates.
To remove a briquette tray, first remove the grates
above the tray, then lift the tray straight up out of the
burner box. (See Figure 4-5)

Zone Dividers

The top edge of the zone dividers is bent into a U-
shape which hooks over studs protruding from the
inside front and rear of the burner box.
To remove a divider, first remove the grates and bri-
quette trays above the divider, then lift the divider up off
of the studs. (See Figure 4-5)
#814144 - Revision A - July, 2009
Outdoor Grill (OG) Series
Set-Screw
Standoff
Mounting
Screws
Figure 4-4. Handle & Endcaps Removal
Zone
Dividers
Figure 4-5. Grates, Briquette Trays & Zone Dividers
4-4
Standoff
Set-Screw
Grates
Briquette
Trays