Lights Power Switch; Burner Hot Surface (Glow) Igniters; Valve Micro-Switch - Wolf OG36-LP Technical & Service Manual

Outdoor Grill (OG) Series

Lights Power Switch

The body of the lights power switch passes through a
hole in the front panel, with a nut on the back side
threaded onto the body of the switch holding it in place.
To remove the switch, first detach the front panel from
the landing ledge as described in steps 1 and 2 of Front
Panel Assembly removal instructions, then (See Figure
4-12):
1. Disconnect electrical leads from switch, noting wire
connection configuration.
2. Use a 7/8" open-end wrench or crescent wrench to
remove retaining nut from back side of switch.
3. Pull switch from front side of panel.
Burner Hot Surface (Glow) Igniter
A burner hot surface igniter is attached to the outside
front of the burner box with a screw; the igniter body
and glow tip protruding into the box through a hole.
To remove an igniter, first detach the front panel from
the landing ledge as described in steps 1 and 2 of Front
Panel Assembly removal instructions, then (See Figure
4-13):
1. Disconnect igniter electrical leads from micro-switch
and wire harness.
2. Extract igniter mounting screw.
3. Pull igniter from front side of burner box.

Valve Micro-switch

The burner valve micro-switch is attached to the top of
a burner valve assembly with screws.
To remove a micro-switch, first detach the front panel
from the landing ledge as described in steps 1 and 2 of
Front Panel Assembly removal instructions, then (See
Figure 4-14):
1. Disconnect electrical leads from micro-switch.
2. Using a small Phillips-head screwdriver, extract
micro-switch mounting screw.
3. Pull switch from top of valve.
Component Access / Removal
Figure 4-12. Lights Power Switch Removal
Figure 4-13. Igniter Removal
Micro-Switch
Figure 4-14. Micro-Switch Removal
4-7
Nut
Switch
Igniter
#814144 - Revision A - july, 2009