Rotisserie Burner Orifice; Ir Rotisserie Burner; Rotisserie Burner Gas Line - Wolf OG36-LP Technical & Service Manual

Outdoor Grill (OG) Series

Rotisserie Burner Orifice

The rotisserie burner orifice is threaded into the end of
the rotisserie burner orifice elbow.
To remove the orifice, first remove the rear hood shell,
then use a 13 mm wrench or crescent wrench to
remove the orifice from the orifice elbow while holding
the elbow with another wrench. (See Figure 4-21)

IR Rotisserie Burner

The IR rotisserie burner is attached to the rear hood
assembly with screws, one each side.
To remove the rotisserie burner, first remove the rear
hood shell, then (See Figure 4-22):
1. Disconnect gas line from orifice elbow.
2. Unthread orifice elbow from burner bracket.
3. Open hood, then extract rotisserie igniter bracket
mounting screws and allow igniter and bracket to
hang freely.
3 Extract burner mounting screws.
4. Pull burner from rear hood assembly.

Rotisserie Burner Gas Line

At the back of the unit, the rotisserie burner gas line is
attached to the orifice elbow. The gas line is then rout-
ed down through a hole in the rear deck of the burner
box and under the side flange up to the elbow that is
attached to the gas valve.
NOTES:
• If the grill is sitting on a cart, the rear panel of the
cart will need to be removed at this time.
• If the unit is built in and there is no rear access to
the grill below the rear hood shell, then the grill will
need to be pulled forward 3" - 6" (76 - 152 mm). If
pulling the grill forward, take care to not damage the
gas supply line.
To remove the rotisserie burner gas line, first remove
the rear hood shell and detach the front panel from the
landing ledge as described in steps 1 and 2 of Front
Panel Assembly removal instructions, then (See Figure
4-23):
1. At front of unit, disconnect rotisserie burner gas line
from elbow attached to gas valve.
2. At back of unit, disconnect gas line from orifice
elbow.
3. Pull gas line down through hole in rear deck of
burner box.
4. Pull the gas line from front to back of unit.
Component Access / Removal
Orifice
Figure 4-21. Rotisserie Burner Orifice Removal
Figure 4-22. Rotisserie Burner Removal
Figure 4-23. Rotisserie Burner Gas Line Removal
4-11
Orifice Elbow
Gas Line
#814144 - Revision A - july, 2009