General Installation Information; Regulations; Important Instructions To The Owner; Locating The Grill - Wolf OG36-LP Technical & Service Manual

Installation Information

GENERAL INSTALLATION INFORMATION

This section of the manual covers some of the installa-
tion issues that a service technician may need to know
when servicing a Wolf Outdoor Grill. If additional instal-
lation information is needed after reviewing this section
of the manual, refer to the complete Installation Guide
or contact Wolf Appliance Customer Service.

Regulations

The installation of a Wolf OG appliance must conform
with local codes or, in the absence of local codes, either
the National Fuel Gas Code, ANZIZ223.1/NFPA54, or
CAN/CGA-B149.1, Natural Gas Installation Code or
CAN/CGA-B149.2, Propane Installation Code.
The utilization of an external electrical source requires
that when installed, a Wolf OG outdoor cooking gas
appliance must be electrically grounded in accordance
with the local codes or, in the absence of local codes,
with the National Electrical Code, ANSI/NFPA70, or the
Canadian Electrical Code, CSAC22.1. Keep any elec-
trical supply cord, or the rotisserie motor cord and the
gas supply hose away from any heated surfaces.
A Wolf OG appliance must be installed in accordance
with National Electrical Codes, as well as all state,
municipal and local codes. The correct voltage, fre-
quency and amperage must be supplied to the appli-
ance from a dedicated, grounded circuit which is pro-
tected by a properly sized circuit breaker or time delay
fuse. The proper voltage, frequency, and amperage rat-
ings are listed on the product rating plate.

Important Instructions to the Owner

• Installation and service must be performed by a
qualified installer, service agency or the gas supplier.
• Warranty service must be performed by a Wolf
authorized service center.
• Do not store or use gasoline or other flammable liq-
uids or vapors in the vicinity of this or any other
appliance. An LP gas cylinder not connected for use
shall not be stored in the vicinity of this or any other
appliance.
• In Massachusetts: All gas products must be installed
using a "Massachusetts" licensed plumber or gasfit-
ter. A "T" handle type manual gas valve must be
installed in the gas supply line to this appliance. This
applies to permanently installed natural gas and
propane installations. This does not apply to propane
portable installations using a 20-lb tank.
#814144 - Revision A - July, 2009
Outdoor Grill (OG) Series

LOCATING THE GRILL

NOTE: A Wolf OG appliance is designed and certified
for outdoor use only. A Wolf OG appliance should
never be operated inside a building, garage, recreation
vehicle or any enclosed area.
When choosing an area for a grill, whether a portable or
built-in application, the following should be considered:
• Exposure to wind - a grill should be kept away from
windy areas but in a well ventilated area. The flow
of combustion and ventilation air around the grill can
not be obstructed.
• Proximity to traffic paths - a grill should be kept
clear of traffic paths.
• Length of gas supply line - The gas supply line
should be kept as short as possible to reduce pres-
sure drop.
• Levelness of application - The grill must be level
and flat. The supporting deck and countertop should
also be level and flat.
DO NOT LOCATE GRILL UNDER OVERHEAD COM-
BUSTIBLE SURFACES!

Portable Applications

Wolf portable grill carts are available to fit all Wolf out-
door grill models (see next page).
2-2