Burner Flash Tubes; Burner (Main And Sear); Control Knobs - Wolf OG36-LP Technical & Service Manual

Outdoor Grill (OG) Series

Burner Flash Tubes

Burner flash tubes are attached to the inside front of the
burner box with screws.
To remove a flash tube, first remove the grates and bri-
quette trays above the flash tune, then use a Phillips-
head screwdriver to extract the flash tube mounting
screws and pull the flash tube from the burner box.
(See Figure 4-6)
NOTE: When reinstalling the flash tube above a sear
burner, be advised that proper spacing may vary by cli-
mate. Begin with a 1/8" (3.2 mm) gap between the bot-
tom edge of the flash tube and the top of the burner tile.
Then, press the control knob in and turn it ON. If igni-
tion takes more that four (4) seconds, readjust the flash
tube up or down as needed. Flash tube spacing is not
an issue above the U-shaped burners.
Burner (Main or Sear)
Brackets at the back of each main U-shaped burner
and the sear burner (not available on 30" model), have
a hole in them that fits over threaded studs protruding
up from the base of the burner box. Nuts threaded onto
the studs hold the burners in place at the rear. At the
front of each burner, the orifice that is attached to the
corresponding gas valve protrudes into the front end of
the burner assembly, holding it in the correct position at
the front.
To remove a burner, first remove the grates and bri-
quette trays above the burner along with the zone
divider nearest the burner, then (See Figure 4-7):
1. Use a 7/16" wrench or crescent wrench to remove
the nut at back of burner.
2. Lift back of burner up until rear bracket clears the
threaded stud, then push burner back to disengage
from the orifice.
3. Lift burner straight up out of the burner box.

Control Knobs

A D-shaped hole at the back of each control knob fits
over the D-shaped shafts of the gas valve assemblies.
To remove a control knob, pull the knob straight off of
the valve shaft (See Fig. 4-8).
NOTE: The nyliner knob insert can be pulled from the
bezel at this time.
Component Access / Removal
Figure 4-6. Flash Tube Removal
Burner
Figure 4-7. Burner Removal
Knob
Figure 4-8. Control Knob Removal
4-5
Flash Tube
Nut
Bezel
Nyliner
Insert
#814144 - Revision A - july, 2009