Your Power Chair - Pride Mobility Jazzy Elite ES Owner's Manual

V . C O M F O R T A D J U S T M E N T S
7. Raise or lower the upper seat post to the desired
position.
8. Reinstall the seat height adjustment hardware to
the seat post.
9. Tighten the hardware at the front of the seat post.
10. Reinstall the seat.
11. Reconnect the controller to the power base.
NOTE: Your power chair may be equipped with an
optional seat release lever. To rotate the seat, use
the seat release lever located under the seat. See
figure 1.
Seat Position
You can move the seat forward or backward by
changing the seat base mounting position.
To change the seat position:
1. Turn off the power to the controller.
2. Make sure the power chair is in drive mode.
3. Unplug the controller connector(s) from the
power base.
4. Remove the seat from the power base.
5. Remove the screws and washers from the bottom
of the seat plate. See figure 11.
6. Slide the seat plate forward or backward, aligning
the holes in the plate with the corresponding holes
on the seat base. You must move both sides of the
seat forward or backward the same number of
holes.
WARNING! Changing the position of
the seat can cause instability. Do not
change your seating configuration
without first contacting Pride Mobility
Products or your authorized Pride
Provider.
WARNING! After any adjustments,
repairs, or service and before use,
make sure
hardware is tightened securely to
prevent injury
damage.
7. Reinstall the screws and washers to the seat plate
and tighten the hardware firmly.
8. Reinstall the seat.
9. Reconnect the controller to the power base.
Jazzy Elite ES Series
that all attaching
and/or equipment
www.pridemobility.com
SEAT PLATE
WARNING! The center of gravity of your
power chair was factory set to a
position that meets the needs of the
demographic majority of users. Your
authorized Pride Provider has evaluated
your power
necessary adjustments to suit your
specific requirements. Adjusting the
seat position can cause instability. Do
not change your seating configuration
without first contacting Pride Mobility
Products
Provider.
Figure 11. Seat Position Adjustment
SEAT BASE
WASHER
SCREW
chair and made
or your authorized Pride
any
15