Front-Facing Webcam - HP Elite x2 1011 G1 Maintenance And Service Manual

Front-facing webcam

NOTE: The front-facing webcam is included in the Webcam Kit, spare part number 793724-001, and
includes double-sided adhesive.
The front-facing webcam spare part kit does not include the front-facing webcam cable. The front-facing
webcam cable is included in the Slate Cable Kit, spare part number 793721-001.
Before removing the front-facing webcam, follow these steps:
1. Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and
then shut it down through the operating system.
2. Disconnect all external devices connected to the slate.
3. Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the slate.
4. Remove the display panel assembly (see
the following components:
a. Battery (see
b. WLAN module (see
c. WWAN module (see
d. Fan (see
e. System board (see
f. Rear-facing webcam (see
Remove the front-facing webcam:
1. Release the ZIF connector (1) to which the front-facing webcam board cable is attached, and then
disconnect the front-facing webcam board cable from the system board.
2. Detach the front-facing webcam board cable (2) from the system board. (The front-facing webcam
board cable is attached to the system board with double-sided adhesive.)
62 Chapter 5 Removal and replacement procedures – slate
Battery on page 36)
WLAN module on page
WWAN module on page
Fan on page 43)
System board on page
Rear-facing webcam on page
Display panel assembly on page
37)
39)
49)
61)
32), and then remove