Setting A Multiboot Express Prompt; Entering Multiboot Express Preferences; Using Hp Pc Hardware Diagnostics (Uefi) (Select Models Only) - HP Elite x2 1011 G1 Maintenance And Service Manual

Setting a MultiBoot Express prompt

To start Slate Setup and set the slate to display the MultiBoot startup location menu each time the slate is
started or restarted, follow these steps:
1. Turn on or restart the slate, and then press
Volume Down button to enter the BIOS Startup Menu" message is displayed at the bottom of the screen.
2. Press or tap
3. Use a pointing device, the arrow keys, or touch the screen to select System Configuration > Boot
Options, and then press enter.
4. In the MultiBoot Express Popup Delay (Sec) field, enter the length of time in seconds that you want the
slate to display the startup location menu before it defaults to the current MultiBoot setting. (When 0 is
selected, the Express Boot startup location menu is not displayed.)
5. To save your changes and exit Slate Setup, click the Save icon in the lower-left corner of the screen, and
then follow the on-screen instructions.
– or –
Select Main > Save Changes and Exit, and then follow the on-screen instructions.
Your changes go into effect when the slate restarts.

Entering MultiBoot Express preferences

When the Express Boot menu is displayed during startup, you have the following choices:
●
To specify a boot device from the Express Boot menu, select your preference within the allotted time,
and then press enter.
●
To prevent the slate from defaulting to the current MultiBoot setting, press any key before the allotted
time expires. The slate will not start until you select a boot device and press enter.
●
To allow the slate to start according to the current MultiBoot settings, wait for the allotted time to
expire.

Using HP PC Hardware Diagnostics (UEFI) (select models only)

HP PC Hardware Diagnostics is a Unified Extensible Firmware Interface (UEFI) that allows you to run
diagnostic tests to determine if the slate hardware is functioning properly. The tool runs outside of the
operating system to isolate hardware failures from issues that may be caused by the operating system or
other software components.
To start HP PC Hardware Diagnostics UEFI:
1. Turn on or restart the slate, quickly press esc, and then press f2.
After pressing f2, the BIOS searches three places for the HP PC Hardware Diagnostics (UEFI) tools in the
following order:
a. Connected USB drive
f10 to enter Slate Setup.
esc or hold down the volume button while the "Hold the
Using HP PC Hardware Diagnostics (UEFI) (select models only) 93