LG BECON HVAC BACnet PQNFB17C1 Installation & User Manual page 43

Setting Vnet Number
To use Modbus TCP function of ACP BACnet, Vnet Number must be set.
Set Vnet Number is used to Slave ID Address of Modbus TCP.
Proceed in the following order.
1.
When you press [SET] button, menu screen will be displayed. Use up and down (▲, ▼) buttons
of the ACP BACnet to select [Contents], and press [SET] button again. While [Vnet No] is
selected, pressing [SET] button will display the screen to set Vnet Number.
PQNFB17C0
Software service function
The following software service function can be run using the menu of the ACP BACnet.
This function shall only be used by the specialized service technician, and negligent use may cause
failure of the ACP BACnet system.
• Software update
• Data backup
• Data recovery
• RS-485 data logging
Network Info
> Contents
Function
Register FD
Click
[SET]
button
[ Contents 2/2 ]
Device ID
>
Vnet No
Click
[SET]
button
[ Set VNET NO ]
000010
INSTALLING ACP BACnet
9000
10
33