Table of Contents
Advertisement
Installation
Assembly
This
appliance
qualified / trained persons only.
Only qualified service persons are to carry out installation and servicing of
this appliance.
All Models
All models come pre-assembled.
NOTE: This appliance is fitted with adjustable feet / castors to enable the unit to be positioned
securely and level. This should be carried out on completion of the electrical connection.
Refer to the 'Electrical Connection' section.
Optional Accessories (Refer to Replacement Parts List)
Plinth Kit. For installation details, refer to the instructions supplied with each kit.
Electrical Connection
T
HIS APPLIANCE MUST BE EARTHED
QUALIFIED PERSON IN ORDER TO AVOID A HAZARD
NOTE: ALL ELECTRICAL CONNECTIONS MUST ONLY BE CARRIED OUT BY AN AUTHORISED
PERSON.
Each appliance should be connected to an adequately protected power supply and isolation switch mounted
adjacent to, but not behind the appliance. This switch must be clearly marked and readily accessible in
case of fire.
1.
Check that the electricity supply is correct as shown on the Rating
Plate. (Refer to the dimension drawings for rating plate location).
2.
The supply terminal connections are located at the rear of the the
appliance. Refer to 'Electrical Connections' in the 'Specifications'
section of the manual.
3.
Remove the control panel to allow connection access for the
electrical supply.
4.
Bring the supply cable up through the grommet at the back of the
appliance and through the compression type gland provided on
the rear of the main electrical switchgear panel.
5.
Connect the mains supply to L1, L2 and L3 fuse carrier
connections for 3 phase.
6.
Connect neutral and earth conductors to neutral stud and earth
stud respectively.
7.
For all connections ensure that conductors are secure and
appropriately terminated.
8.
Tighten the cable gland to secure against tension on the cable.
NOTE:
This appliance must be grounded / earthed.
Fixed wiring installations must incorporate an all-pole disconnection switch.
9.
Correctly locate the appliance into its final operating position and using a spirit level, adjust the legs
so that the appliance is level and at the correct height.
10.
Connect the power supply to the appliance.
11.
Check that the electrical supply is as shown in the 'Specifications' section.
C
AUTIO N
is
for
professional
WARNING:
. I
F THE SUPPLY CORD IS DAMAGED
.
:
use
and
is
to
,
IT MUST BE REPLACED BY A SUITABLY
6
be
used
by
suitably
Rating Plate
Location
Fig 1
Advertisement
Table of Contents
