Table of Contents
Advertisement
IMPORTANT - To the user - This manual is a guide for installing, operating, and maintaining this
equipment. Please read and maintain this document for service and troubleshooting.
G
D
ENERAL
ESCRIPTION
The LANDMARK Ice Dispenser consists of an ice storage bin and an ice dispensing system.
Wilshire LANDMARK ICE DISPENSERS are designed to dispense any type of hard cube ice, up to one
inch square, and will dispense some types of extruded ice. The use of flaked ice and "super cold ice" are
not recommended.
ID-90 Series
NOTICE -
(800-654-1729) for a top adapter and to verify that the ice maker is compatible with the
LANDMARK. Incompatible cube size and/or installation of an ice maker without the proper top
adapter can cause damage to the dispenser. FAILURE TO COMPLY WITH THESE
REQUIREMENTS WILL VOID THE WARRANTY.
NOTE: When using extruded ice, the agitator motor timer relay must be bypassed. Refer to wiring
diagram on page 6.
U
I
NPACKING AND
The unit was thoroughly inspected before leaving the factory. Any damage should be noted at the time of
delivery (no later than 15 days from date of delivery) and immediately reported to the carrier. File the
claim with the delivering carrier.
After removal of shipping carton, remove parts from the ice compartment.
L
R
OCATION
EQUIREMENTS
Use a separate 120VAC, 60HZ 1PH, 15 AMP grounded duplex outlet to accommodate each dispenser.
Locate the outlet within three (3) feet of the dispenser. Extension cords cannot be used. ALL
ELECTRICAL WIRING MUST CONFORM TO NATIONAL AND LOCAL ELECTRICAL CODES. (See
Wiring Diagrams, FIGURE 1)
The counter must be able to support 250 pounds, which includes dispenser and ice.
I
U
NSTALLING
NIT
With the template provided in the installation kit, mark the outline of the Ice Dispenser on the counter
surface and location for drain line. Apply a 1/2 inch wide bead of silastic (such as Dow Corning 732)
within the dispenser outline. Place the Ice Dispenser on top of the silastic. Wipe the excess silastic
creating a smooth seal. All holes cut in counter top for product, drain, and electrical lines must be sealed
with an acceptable material in accordance with local, state health, and building codes.
Attach the drain hose and clamps to the bottom of the drip pan assembly. Connect the unit to a drain
outlet according to state and local requirements.
Place the ice trap in the drain outlet in the ice bin. This holds ice away from drain outlet and allows water
to drain properly.
Check connection for leaks.
IMPORTANT - SYSTEM MUST BE SANITIZED AS INSTRUCTED PRIOR TO OPERATION. See
Cleaning and Sanitizing Instructions.
© 2004-2014, Cornelius Inc.
Model
Width
15.00"
PRIOR TO ICE MAKER INSTALLATION: Contact Wilshire Customer Service
NSPECTION
Landmark Ice Dispenser Installation and Service Manual
Cabinet
Depth
Height
21.00"
34.50"
- 1 -
Ice Storage
Capacity
90#
Publication Number: 60418002
Advertisement
Table of Contents
