Record Custom Voice Descriptors - Safewatch QuickConnect Plus Programming Manual

Use this mode to record up to 5 custom voice descriptors for use with zone announcements. Press
programming mode.
NOTE: Entry of a number other than one specified will give unpredictable results.
85 85 85 85
REC REC VOICE VOICE DESCR DESCR
REC REC VOICE VOICE DESCR DESCR
A A A A
CUSTOM DESC CUSTOM CUSTOM CUSTOM DESC # DESC DESC

6 6 6 6 85 RECORD CUSTOM VOICE DESCRIPTORS

Record Custom Voice Descriptors
0 = Exit mode, upon which this prompt blinks.
1 = Enter mode
Custom Descriptor Number
Enter 7 + d + [ ]
6
where d = 0-4, each representing custom word 70, 71, 72, 73 or 74 respectively. Existing
descriptor will be announced.
Press [#] to start recorder. Begin speaking immediately after the third beep.
Speak the desired word clearly near the keypad microphone. Recording stops after 1.5
seconds.
6 = Accept word and ready to record next descriptor (prompt A....7d)
[#] = Re-record descriptor
00 = Exit Record mode after pressing 6 (displays blinking 85; enter
or menu mode number)
Press any other key to repeat the recorded word.
- 21 -
85 while in
6
+ desired data field
6