Step 1B - Mount Ram Clamp To Vehicle - Honeywell Thor VM2 Reference Manual

Vehicle-mount computer
Hide thumbs Also See for Thor VM2:
Table of Contents

Advertisement

Step 1b – Mount RAM Clamp to Vehicle
Note:
If you are using the RAM ball mount, please go to
1c.
1. Determine the position for mounting the RAM clamp mount. The clamp mount can be used on a beam (such as on a fork
lift truck) up to 2.5" (63.5 mm) wide and approximately 2" (50.8 mm) thick. The clamp may be attached to a thicker beam
by substituting longer bolts (not included). Be sure to position the RAM clamp mount to allow access to the switches
and ports on the bottom of the Thor VM2.
2. Position the upper clamp piece with ball (A) on the beam. Place the bolts (B) through the holes in the upper clamp piece.
3. Position the lower clamp piece (C) below the beam. Align the bolts with the holes in the lower clamp piece.
4. Place the nylon locking nuts (D) on the bolts and tighten the bolts.
2-6
Step
1a. If you are using the RAM plate mount, please go to
Step

Advertisement

Table of Contents
loading

Table of Contents