MobileDemand xTablet T1600 User Manual page 50

The GPS application cannot find my
location.
No sound is produced.
Barcode scanner does not emit light
and does not seem to work.
Barcode Scanner emits light but does
not read barcode presented to it.
• If just starting the tablet from power off, it
may take several minutes for signal to be
acquired.
• Make sure that GPS receiver and the
location sensor are enabled in Control
Panel.
• The xTablet T1600 may be out of
coverage area. Move your xTablet T1600
outdoors or closer to a window.
• Check if your surroundings have
interference, such as microwave ovens,
cordless phones. Move the xTablet T1600
away from objects causing interference.
• Adjust volume of the xTablet T1600 by
adjusting the volume on the toolbar by
clicking on the speaker icon.
• If using an external audio device, make
sure that the cable is properly connected.
• Make sure the Barcode scanner software
is running by checking for the MDScanner
utility down on the toolbar by the clock.
• Adjust the distance between barcode
scanner of the device and the barcode
being scanned.
• Make sure the barcode code type is
enabled in the tablet. To enable/disable a
specific barcode code type, use Intermec
EasySet program located in the driver's
folder located off the root of the C:\ drive.
• Clean the scanner lens with a damp clean
cloth.
50 xTablet T1600 User Guide