SPRT
Fig.2-8 Closing the Movable Cover Panel
2.4 Paper Roll Installation
For SP-T printers, paper roll can be put inside the case, installing paper as
follows:
(1) Push the removable cover plate forward till it off the printer like
Fig.2-2,
(2) Cut the paper end like Fig.2-10 below.
For paper roll placed inside the case: Insert the paper end downwards into
paper-in slot on rear of printer mechanism like Fig. 2-11, Fig.2-12 paper
upward is not correct.
For paper roll hold outside the case: firstly put paper through the narrow
orifice that is at the back of printer shell, as shown in Fig 2-12, then make
paper face the paper-in slot.
Fig 2-9 Sample of Paper End
Fig.2-10 Paper End Downwards
Fig. 2-11 Paper End Upwards Is Wrong
8