Lcd Cannot Be Seen At Aii; An Unintended Language Is Displayed On The Lcd - Canon PIXMA MP970 series Quick Start Manual

Message Action
"The following ink tank cannot be
• The ink tank is not installed. Install the ink tank.
recognized."
See "Replacing an Ink Tank" on page 50.
U043
• The ink tank is not compatible with this machine. (The lamp on the ink tank is
U140
off.)
U150
Install an appropriate ink tank.
See "Replacing an Ink Tank" on page 50.
• An ink tank error has occurred. (The lamp on the ink tank is off.)
Replace the ink tank.
See "Replacing an Ink Tank" on page 50.
"**** Turn off the machine, and unplug the power cord of the machine from the power
Printer error has occurred. supply. After a while, plug the power cord of the machine back in, and then turn
Turn off power then back on again. If on the machine. If the same error occurs, contact a Canon service
problem persists, see the manual." representative.
"Scanner is not operating correctly." Turn off the machine, and unplug the power cord of the machine from the power
supply. After a while, plug the power cord of the machine back in, and then turn
on the machine. If the same error occurs, contact a Canon service
representative.
"Release the scanner lock switch and The Scanner Lock Switch is not released. Slide the Scanner Lock Switch to the
turn the power off and back on." release position
"rn
and press the ON/OFF button to turn the machine off.
Then, turn the power back on.
If this error still remains, contact a Canon service representative.
"The card is currently write-enabled. The Card Slot is set to USB enabled or LAN enabled.
Set to read-only mode before
You cannot print when the Card Slot is set to USB enabled or LAN enabled.
performing operation."
After writing on the memory card, set to Read-only mode again.
I
"An unsupported USB hub is
If a PictBridge compliant device is connected via a USB hub, remove the hub
connected. and connect it directly to the machine.
Remove the hub."
LCD Cannot Be Seen At All
Cause Action
The machine is not powered on or the
LCD is in the screen-saver mode.
• If the Power lamp is off
The machine is not powered on. Connect the power cord and press the ON/
OFF button. The machine will power on and the LCD will display a message.
• If the Power lamp is lit
The LCD may be in the screen-saver mode. On the Operation Panel, press a
button other than the ON/OFF button.
An Unintended Language Is Displayed on the LCD
Cause Action
The language you want to be displayed
is not selected.
Select the language you want to be displayed according to the following
procedure.
(1)Press the HOME button. Wait for about 5 seconds, select
lW,
and then
press the OK button.
(2) Press the. button to select
._~j,
then press the OK button.
(3) Press the. button five times, then press the OK button.
If the Bluetooth unit is connected to the machine, press the. button six
times, and then press the OK button.
(4) Use the" or. button to select the language you want to be displayed, then
press the OK button.
76
Troubleshooting