maintenance
|
40
VALVE REPLACEMENT
If the valve requires maintenance or replacement,
use the following instructions:
Note: Always shut off the gas supply and turn
off electrical before removing the valve.
1. Remove safety screen and open front pedestal
door. You may want to put a soft cloth on the
base of the unit so that when the pedestal door
is open it doesn't scratch the paint.
2. Remove 2 screws to remove receiver cover.
3. Remove chain from door and unit,remove 4
screws holding the access panel in place.
Receiver cover
Chain slot
4. Disconnect receiver wire from the back of the
panel and then remove panel. Set the panel
on a soft cloth so it doesn't get scratched.
5. Disconnect stepper motor wire.
Stepper motor wire
6. If fan installed–disconnect the "Com" wire from
the valve.
7. Disconnect the DC spark generator wires from
the valve.
40 |
Regency
U39-10 ULTIMATE Direct Vent Freestanding Gas Stove
®
8. Disconnect the gas at the valve. Access throught
the front (with access panel removed) The gas
line may also be accessed by removing the rear
pedestal cover plate.
9. Carefully remove the logs and lava rock.
10. Remove two (2) screws to remove burner.
Note: Use a magnetic type screwdriver if
possible.
11. Remove all 18 screws holding the burner tray
assembly in place.
12. Carefully lift the valve tray assembly out.
Access panel
13. Remove the valve tray and replace.
14 Reverse Steps 1-11 to complete.