Valve Replacement - Regency ULTIMATE U38 Owners & Installation Manual

VALVE REPLACEMENT

If your valve requires maintenance or replace-
ment, follow these instructions:
NOTE: Always shut off the gas and electrical
supply before removing the valve.
1) Remove safety screen and open front
pedestal door. You may want to put a soft
cloth on the base of the unit so that when
the pedestal door is open it doesn't scratch
the paint.
2) Undo the four screws holding the control
panel in place.
3) Disconnect all the receiver wires from the
back of the panel and then remove panel.
You should lay the panel on a soft cloth so
it doesn't get marked up.
Receiver cover
Chain slot
4) Disconnect the Stepper Motor wire..
5) Disconnect "com" wire that leads to the fan
module if installed.
6) Carefully remove the logs and lava rock.
7) At this point you should disconnect the gas
at the valve.
8) Remove the burner by removing the two
1/4" hex head screws. See diagram below.
Note: Use a magnetic type screwdriver.
9) Remove eight 1/4" hex head screws holding
the burner tray assembly in place.
10) Carefully lift the burner tray assembly out.
Access panel
11) To replace the burner tray assembly, simply
reverse these instructions.
maintenance
Regency U38-10 ULTIMATE Freestanding Gas Stove
®
|
25
| 25