Glass Gasket; Glass Replacement; Valve Assembly Replacement - Regency C34 Classic Owners & Installation Manual

GLASS GASKET

GLASS
REPLACEMENT
Your CLASSIC stove is supplied with high tem-
will withstand the highest heat that your unit will
impact, purchase your replacement glass from an
dealer only.
®
REMOVING VALVE
ASSEMBLY
1.
2. If optional fan is installed, disconnect power
source to stove.
3. Remove access panel.
a) Front panel on pedestal model.
See Diagram 1.
b) Panel from bottom of leg shield.
Note: Access panel only has to be loosened
to be taken out.
4.
screws.
5. Disconnect receiver wire.
6. Remove cover plate by removing 4 screws
Cover Plate
Access Panel
Diagram 1
Diagram 2
7. Disconnect gas line to stove.
8.
valve.
9.
10.
11.
12.
assembly down.
Regency
maintenance
continue.
Valve Cover
13.
Plate
14.
wrench.
15. Remove pilot nut with an 11 mm wrench.
16.
wrench.
17. Remove inlet pipe with pipe wrench. Note
orientation of 90
18.
each side of the valve.
19. Remove valve and remove gas out 90
INSTALLING
VALVE ASSEMBLY
1. To install a new valve assembly, reverse
instructions for
sembly steps 1-10.
2.
Gas Pressure Test instructions.
3. To reinstall valve, reverse instructions for
elbow on
o
CLASSIC™ C34-10 Direct Vent Freestanding Gas Stove
®
|
37
elbow.
o
brass
o
. See as-
| 37