Final Installation; Placement Of Lava Rock, Rock Wool And Logs - Majestic 300DVBH Installation And Operating Instructions Manual

PLACEMENT OF LAVA ROCK, ROCK WOOL
AND LOGS
1. Make sure that the grate is hooked onto the rear
bracket.
2. Sprinkle the lava rocks around and in front of the burner
at bottom of firebox.
3. Place rock wool in a dime size pieces over the small
holes and partially over large size holes. Do not place
any over slots at rear of burner. The rock wool over
the large holes may need adjustment after firing the
unit to establish yellow flame in the front. See Figure
46.
4. Place log #1 into place by setting the log over the two
pins on the grate toward the back. The two round holes
on the bottom of the logs should go over the two pins
on the grate. See Figure 47.
5. Place log #2 into place by matching the two holes on
the bottom of the log with the two pins located on top
of the burner. When this log is in place it is positioned
at an angle and the right side of the log is seated over
the right tong of the grate. See Figure 48.
Do not use the entire bag of rock wool to
cover the burner. This could cause the flame
to burn poorly and may lead to sooting.
Do not sprinkle the lava rock or ember
chunks on top of the burner. This may cause
potential sooting, glass breakage and a fire
hazard.
54D5032
Cover with
Rock Wool
Figure 45 a & b - Placement of Rock Wool
Figure 46 - Placement of Rock Wool on Burner
Figure 47 - Placement of Log 1

FINAL INSTALLATION

300DVBH
400DVBH
on Burners
Burner
Log #1
33