Table of Contents
Advertisement
Rack Installation
Warning
To avoid injury, lifting the
chassis requires two people.
14
Chapter 2 | Installation and Setup
In f oC as t er R ac km o u nt H ar dw a r e In sta ll at io n M a n ua l
After you have installed the inner slides on the chassis, you are ready to install
the outer slides to the rack.
1
Insert the intermediate slide fully into the outer slide from the rear until it
locks in place.
2
Secure an end bracket and a bar nut to the rear of the outer slide with the
screws provided.
Rack Front
3
Secure the outer slide end bracket assembly to the rear of the rack with a
bar nut and the screws provided.
4
Secure the front of the outer slide to the front of the rack with a bar nut
and the screws provided.
5
Repeat the above steps to install the other outer slide on the opposite side
of the rack.
6
Slide the chassis into the rack. Some adjustment to the slide assemblies
might be needed as the chassis may not slide into the rack smoothly or
easily when installed the first time.
7
In order to completely remove the chassis from the rack, you need to press
the release tabs on both sides of the chassis.
End Bracket
Outer Slide
Figure 2-3. Rack Installation
Rack Rear
Bar Nuts
Advertisement
Table of Contents
