Installation - Viking DFBB536 Installation Manual

General Information
• Most of the unit's weight is at the top. Extra Tip Over Hazard
care is needed when moving the unit to Appliance is top heavy and tips easily when not
prevent tipping. completely installed. Keep doors closed until
appliance is completely installed and secured per
• DO NOT remove protective film until unit is in installation instructions. Use two or more people
operating position. to move and install the appliance. Failure to do
so can result in death or serious injury.
• All four leveling legs must make contact with
Unpacking unit
the floor to support and stabilize the full weight.
1. Remove top and bottom strap.
• DO NOT drop unit.
2. Remove top cap.
• Remove exterior shipping materials prior to
moving unit into home. 3. Cut rear of carton approximately 1/4" (0.6 cm)
• Use two or more people to move and install
unit. Failure to follow this instruction can result
in back or other injury. 4. Remove carton and exterior packaging.
• To avoid personal injury, wear gloves when
performing any installation procedure and wear
eye protection when cutting metal straps.
Moving Unit
1
Remove shipping brackets from skid by Slip cart between unit and skid. Remove unit from skid.
removing four bolts (two on each side) with a Note: Use excess packaging to protect decorative trim;
1/2" deep-well socket wench and a pair of pliers.
Note: Tilting unit is not required to remove
shipping brackets.
58
to 1" (2.5 cm) from right corner with a utility
knife extended 1/4" (0.6 cm).
Save cardboard shipping material to protect
floor surface when installing unit. Remove
anti-tip board, kickplate and door trim pieces
(DF models) from rear of unit.
2
also, verify that leveling legs are up (0" adjustment).

Installation

1
Place unit in front of cutout.
2b
Designer
Pull the center grille louver up
at an angle and pull out.
4
Remove grille assembly.
59
2a
Professional
Lift center grille louver up
and pull out.
3
Using an 8" magnetic nut driver,
remove the two 1/4" screws.