Time Display; Standby - Miele TX2070 Operating Instructions Manual

Time display

The duration of the programme
selected appears in hours and minutes
in the display before the programme
begins. During the programme, the
time left until the end of the programme
is displayed.
The time displayed may vary with the
same programme. This is partly
because of the water temperature at
each intake, the reactivation cycle, the
type of detergent and partly because of
the amount of crockery and how dirty it
is.
When a programme is selected for the
first time, the display shows an average
time for a cold water intake.
The times shown in the Programme
chart refer to standard test loads and
temperatures.
Each time a programme is run, the
electronic unit takes the new conditions
into account, and calculates the time
required.

Standby

To save energy, the dishwasher will
switch to Standby mode a few minutes
after the last time a button has been
pressed or at the end of the
programme. The indicator lights and
the time display will go out, and only
the K indicator will flash slowly.
^ To switch the lights and display back
on, press the K button.
If the dishwasher is not switched off at
the end of the programme, it will switch
off completely after a few minutes in
Standby mode (see "Additional
functions - Optimise standby").
The dishwasher will not switch to
Standby mode whilst a programme
is running, if salt or rinse aid needs
to be refilled, or if there is a fault.
The refill indicators can be switched
off if you use combination products
and the dishwasher is supposed to
go into Standby mode (see "Before
using for the first time").
However, a fault message cannot be
switched off.
Operation
39