Water Connection; The Miele Waterproof System; Connection To The Water Supply - Miele TX2070 Operating Instructions Manual

Water connection

The Miele Waterproof system

Provided that your dishwasher has
been installed correctly, the Miele
waterproof anti-leak system will protect
you from water damage throughout its
lifetime.
Connection to the water
supply
,
Water in the dishwasher must
not be used as drinking water.
,
IMPORTANT Australia and New
Zealand
This appliance must be installed
according to AS/NZS 3500.1. Back
flow prevention is already integrated
in the appliance.
– The dishwasher may be connected
to a cold or hot water supply, max.
60 °C.
We would only recommend
connection to a hot water supply if it
is economical. When connected to a
hot water supply, all programme
stages which would otherwise be
carried out with cold water will be
carried out with hot water, thus
increasing time and energy costs.
– The inlet hose is approx. 1.5 m long.
3
– A / " male thread must be provided
4
on site.
72
– Connection to the mains water
supply should only be carried out by
a qualified and competent person in
strict accordance with national and
local safety regulations.
The tap should be easily accessible
once the appliance has been built in.
– The water pressure (flow pressure at
the take-off point) must be between
30 and 1000 kPa (0.3 and 10 bar). If
the water pressure is too high, a
pressure reducing valve must be
fitted.
After commissioning the appliance,
ensure that the water inlet does not
leak.
,
To avoid any damage to the
appliance, the dishwasher must only
be connected to a fully vented
plumbing system.