Optimise Standby - Miele TX2070 Operating Instructions Manual

Additional options

Optimise standby

To save energy, the dishwasher will
switch to Standby mode a few minutes
after the last time a button has been
pressed or at the end of the
programme. The indicator lights and
the time display will go out, and only
the K indicator light will flash slowly.
If the dishwasher is not switched off at
the end of the programme or the door is
not opened, it will switch off completely
after a few minutes in Standby mode.
The Optimise standby function can be
deactivated if wished. The display and
the indicator lights will not go out, and
the time lapse before the dishwasher
switches off will increase to approx. 6
hours, resulting in higher energy
consumption.
The dishwasher will not switch to
Standby mode whilst a programme
is running, if salt or rinse aid needs
to be refilled, or if there is a fault.
46
^ Open the door.
^ Switch the dishwasher off with the K
button.
^ Press the Programme selector button
in and, whilst holding it in, switch
the dishwasher on using the On/Off
button K.
Keep the Programme selector button
pressed in for at least four seconds
until the lower right-hand indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Turbo button eight times.
The Turbo indicator light will flash
briefly 8 times at intervals.
The flashing sequence in the time
display shows whether the "Optimise
standby" function is activated or
deactivated.
– "p 1": "Optimise standby" is activated.
– "p 0": "Optimise standby" is
deactivated.
^ To change the setting, press the
Programme selector button.
The setting is now stored in memory.
^ Switch the dishwasher off with the K
button.