Accessories Installation And Basic Functions; Accessories Installation - WINBO WB20141117 User Manual

User Manual for WINBO 3D Printers
Advanced settings:
（1）Nozzle size: 0.4mm (fixed).
（2）Speed（retraction）: the speed for retraction. Retraction is pulling the filament back when moving over a
gap in the print.
（3）Distance（retraction）: if it is 0, it mean no retraction made at all.
（4）Initial layer thickness: a thicker layer gives a thicker bottom layer which is easy to stick to the platform. If
it is 0, it means the same bottom layer as the printing layer.
（5）Cut off object bottom: Cut the bottom of the model, this effectively sinks the object into the printer bed. If
your object does not have a lot of contact area with the printer bed then this feature could help you.
（6）Travel speed: the speed at which the printhead moves when it is not printing.
（7）Bottom layer speed: the speed at which the printhead moves while it is laying down the first layer. This is
done to make the print stick easier.
（8） Minimal layer time: the minimal time spent on printing a single layer. If a layer takes less time to print than
this configured time, then the layer is cooled down. This ensures that a layer is cooled down and solid
enough before the next one is put on top.
（9）Enable cooling fan: the cooling fan is usually enabled and greatly improves print quality for PLA.
Note: for the Advanced setting, normally, they are default and require little adjustment.
D. Accessories Installation and Basic Functions
D.1 Accessories Installation
Unpacking the machine, you need to install the accessories:
7
Version: WB20141117