Change Filament During Printing - WINBO WB20141117 User Manual

User Manual for WINBO 3D Printers
1
On the main menu
"prepare""preheat
PLA"or"Preheat ABS" to heat the
extruder
4
Material comes out of the nozzle
evenly
Tips: If the filament refuses to go into the feeder, you may need to preheat the extruder first and then go to the
LCD pane: "Prepare" → "Move Axis" → "Move 1mm" → "Move Extruder" to make the value as 100 or above.
After that, you may push the filament into the feeder as shown below:
D.2.4 Change Filament During Printing
If you find that the material is running out during printing or you want to change another color, you may do as
shown below. (Note: the yellow material is the current one while the green one is the new material).
2
Push the filament through with
strength until the filament passes the
gear to the tube
5
Insert the tube to the extruder
After heating, insert the filament to
the extruder and push it down a
Put back the blue buckle
11
Version: WB20141117
3
little
6