Full Settings Printing - WINBO WB20141117 User Manual

User Manual for WINBO 3D Printers
C.3 FULL SETTINGS PRINTING
Choose "Tools" under the menu"Switch to full settings" as below:
BASIC SETTINGS ARE AS BELOW:
（1） Layer height: thickness for each layer. Normally it is 0.15mm. If you need high resolution, you may
choose smaller one.
（2） Shell thickness: the amount should bea multiple of 0.4. You may need to adjust this amount to get the
best printing quality.
（3） Enable retraction: Retract the filament while it is not printing. Enable recommended, otherwise, it will
create fine lines during printing.
（4） Bottom/Top thickness: it is related to the printing speed.
（5） Fill Density: normally it is 10-30%.
（6） Print Speed: the faster the print speed, the faster the feeding speed. And the result is burrs created
during printing.
（7） Printing Temperature: 230℃ for ABS, PETG and PLA.
（8） Bed Temperature: 0℃ for PLA and 70℃ for ABS.
（9） Support Type: to choose where to print the support.
（10） Platform adhesion type: a setting to help the printed object stick to the printer bed.
（11） Diameter: you may put the actual diameter.
（12） Flow (%):100% for PLA and 85% for ABS.
6
Version: WB20141117