Viem Mode; Print From Sd Card (Recommended) - WINBO WB20141117 User Manual

User Manual for WINBO 3D Printers
Note: Slit object into parts is to separate two models instead of slitting a model into two parts.
A whole
F.1.5 VIEM MODE
You may adjust the view mode for better checking and editing on the model.
Click on and you may change view mode for the model as below:
Scenograph view mode
F.2 PRINT FROM SD CARD (RECOMMENDED)
After editting, you may save it into SD card as G-Code. Insert the SD card and click on "Toolpath to SD"
to save the model. The model is saved into SD card automatically. If there is no SD card, click on "Save
Split into two models
Standard view mode
Pending view mode
Standard view mode Pending view mode Scenograph view mode
X-Ray view mode
Layering view mode
X-Ray view mode
Two wholes
Layering view mode
17
Version: WB20141117