Msr Input - Motorola MC32N0 Integrator Manual

- Disable – Disables Picklist mode. Any bar code within the field of view can be decoded (default).
- Centered - Enables the Picklist mode so that only the bar code in the center of the image is decoded. This is
most useful when used in conjunction with the static and dynamic reticle viewfinder modes. Note: This mode
is only valid for decoder modules that supports a viewfinder. If one tries to set this for a unsupported decoder
then the device would issue an error. (Camera scanner only).
- Reticle - Enables the Picklist mode so that only the bar code that is directly under the cross-hair (reticle) is
decoded. This is useful when used in conjunction with the static and dynamic reticle viewfinder modes. (Scan
Module Only)
• LCD Mode - Enables or disables LCD mode. LCD mode enhances the ability of the imager to read bar codes
from LCD displays such as cellphones (imager only).
- Disable - Disables the LCD mode (default).
- Enable - Enables LCD mode.
Note: When using the LCD mode, a degradation in performance may be observed and the aiming
crosshair may blink until the bar code is decoded.
• Illumination mode - Turns camera illumination on and off. This option is only available when camera is selected
in the Barcode input Scanner selection option.
- On - Illumination is on.
- Off - Illumination is off (default).
• Inverse 1D Mode - This parameter allows the user to select decoding on inverse 1D bar codes.
- Disable - Disables decoding of inverse 1D bar codes (default).
- Enable - Enables decoding of only inverse 1D bar codes.
- Auto - Allows decoding of both twice positive and inverse 1D bar codes.
• Viewfinder Mode - Configures the Viewfinder modes supported for camera scanning.
- Viewfinder Enabled - Enables only the viewfinder.
- Static Reticle - Enables the viewfinder and a red reticle in the center of the screen which helps selecting the
bar code (default).
Scan Params
Allows the configuration of Code ID and decode feedback options.
• Code ID Type - A Code ID character identifies the code type of a scanned bar code. This is useful when the
reader is decoding more than one code type. Select a code ID character to insert between the prefix and the
decoded symbol.
- Code ID Type None - No prefix (default).
- Code ID Type Aim - A standards based three character prefix.
- Code ID Type Symbol - A Symbol defined single character prefix.
Note: Not all ringtones are fully supported as decode tones and those of longer length may be truncated
when used as a decode tone. The recommendation is to test the selected tone for operation before
deployment to a customer site.
• Decode Audio Feedback - Select an audio tone to sound upon a good decode.
• Decode Haptic Feedback - Enable the device to vibrate upon a good decode (default - enabled).

MSR Input

Use MSR Input options to configure the MSR Input Plug-in for the profile.
• Enabled — Enables or disables this plug-in. A check in the checkbox indicates that the plug-in is enabled.
DataWedge Configuration | 69
MN000887A01-B | April 2015