gledhill GB10 Installation And Servicing Instructions page 5

(d) If you have a sealed heating system, contact your installation/service company as draining, refilling and
pressurising MUST be carried out by a competent person.
(e) As a safety feature, the boiler will stop working if the condensate drain becomes blocked. During
freezing conditions this may be due to the forming of ice in the condensate drain external to the house.
Release ice blockage by use of warm cloths on the pipe. Contact your installation/service company if
the fault persists.
1.9.
BOILER INSTALLATION IN A COMPARTMENT OR CUPBOARD
If the boiler is fitted into a compartment or a cupboard, it does not require ventilation openings. However, do
not use the compartment or cupboard for storage.
1.10.
BOILER CASING
Do not remove or adjust the casing in any way, as the incorrect fitting may result in incorrect operation or
failure to operate at all.
1.11.
CONDENSATE DRAIN
The condensate drain must not be modified or blocked (See section 3.13)
1.12.
PLUMING FROM FLUE TERMINAL
This is a high efficiency-condensing boiler and hence flue gas temperature will be low. Therefore like all
condensing boilers this appliance will produce a plume of condensation in cool weather. It is normal and not
a fault condition, but this should be taken into account when positioning the boiler.
1.13.
CLEANING
This boiler contains metal parts and therefore care should be taken when handling and cleaning, with
particular regard to edges.
The boiler casing can be cleaned using a mild liquid detergent with a damp cloth and then a dry cloth to
polish. Do not use any form of abrasive or solvent cleaner as you may damage the finish.
1.14.
MAINTENANCE AND SERVICING
This appliance must be serviced and installed by a competent person e.g. CORGI Registered installer. All
CORGI registered installers carry a CORGI ID Card and have a registration number. You can call CORGI
direct on 01256 372300.
For the continued efficient and safe operation of the boiler, it is recommended that it is checked and serviced
at regular intervals. The frequency of service will depend upon the installation condition and usage, but in
general, once a year should be enough.
If this boiler is installed in a rented property, there is a duty of care imposed on the owner of the property by
the current issue of the Gas Safety (Installation and Use) regulations, Section 35.
The installation / service engineer should complete the 'Benchmark' logbook on completion of commissioning
and service work.
VER: 02.3 _260505
Supplied By www.heating spares.co Tel. 0161 620 6677
Page:5/41