Carrier Information For Mtd-Ev3; Verizon Activation; Sprint Activations - Multitech MTD-H5 User Manual

Carrier Information for MTD-EV3

Verizon Activation

1. Send ATD*22899;<cr>
2. Wait for response OK
3. Wait for response #OTASP:0
4. Wait for response #OTASP:1
5. Wait for response #OTASP:2
6. Modem will reset when done with the activation.
7. Close terminal program
8. Unplug and replug the USB cable
9. Check registry with AT_REG?
Check the Multi-Tech web site for the latest information regarding activations.

Sprint Activations

Sprint performs OTA activations automatically. Watch for their OMA messages for various Sprint updates. Do not
power off or reset the unit if the device is in the middle of an OTA update.
Applications should look for the following unsolicited OMA indications at all times:
#904 HFA Started
#905 PRL - Session started
#906 DC - Session started
#907 FUMO -Session started
If application sees one of these indications it should not attempt to issue commands, attempt data connection, or
reset device until the OMA process is complete as indicated by additional #9XX OMA success or failure indications
below.
If the device is in a data connection when a Network Initiated PRL, DC, or FUMO update alert message is received
from Sprint the radio will wait for a point where data is not being transmitted, then "gracefully" close the data
connection, and then start OMA-DM process with #9xx indication. When this occurs the application should not
attempt to issue AT commands, attempt to start data connection again, or reset device in an attempt to regain
control. Application should wait for a #9xx indication the process has completed before proceeding.
Be aware after the HFA process is successfully completed the radio will be reset. The radio may also reset after
other OMA functions.
11 QuickCarrier USB-D MTD-H5 and MTD-EV3