Xerox Phaser 6022 User Manual page 45

Assigning the IP Address Manually
You can assign a static IP address to your printer from the printer control panel. Once an IP address is
assigned, you can change it using CentreWare Internet Services.
To assign a static IP address to the printer, you need the following information:
• An IP address properly configured for your network
• The Network Mask address
• The default Router/Gateway address
If you are on a network managed by a network administrator, contact your network administrator to
obtain the network information.
For a home network using routers or other devices to connect the printer to the network, refer to the
device instructions on assigning network addresses. The router or device documentation can give you a
range of acceptable address numbers you can use. It is important that the addresses be similar to the IP
addresses used by other printers and computers on the network, but not the same. Only the last digit
must be different. For example, your printer can have the IPv4 address 192.168.1.2 while your computer
has the IP address 192.168.1.3. Another device can have the IP address 192.168.1.4.
The router could assign the static IP address of the printer to another computer that obtains its IP
address dynamically. To avoid having the IP address reassigned, give the printer an address at the
higher end of the range allowed by the router or device. For example, if your computer has IP address
192.168.1.2, and your device allows IP addresses to 192.168.1.25, select an address between
192.168.1.20 and 192.168.1.25.
In IPv6 network configurations, the IPv6 address is assigned automatically.
To assign a static IP address to the printer:
1. At the printer control panel, press the Menu button.
2. To select Admin Menu, press the arrow buttons, then press OK.
Navigate to Network, then press OK.
3.
To select TCP/IP, press the Down Arrow button, then press OK.
4.
5. Select an IPv4 mode, then press OK.
At Get IP Address, press OK.
6.
7. To select Panel, press the arrow buttons, then to enable this option, press OK.
To return to the IPv4 menu, press Return once.
8.
To select IP Address, press the arrow buttons, then press OK.
9.
When undefined, the address is 000.000.000.000.
10. Set the IP address.
a. In the first field, to enter the desired number, press the arrow buttons.
b. To move to the next field, press the forward arrow, then enter the desired number.
c. Move to the next two fields, then enter the desired numbers.
Note: To scroll quickly to a number, press the arrows. To return to a field, press the back arrow.
d. When finished, to confirm the address, press OK.
11. To return to IP Address, press the back arrow once.
Installation and Setup
® ®
Xerox Phaser 6022 Printer
User Guide
45